Surface Preparation
The substrate should be sound, clean, free from loose
material, oil, grease, laitance, dirt, curing compound,
etc.
Wet all surfaces (except gypsum board) with clean
water before the application of Vetonit Ultra. The
surface should appear damp with no water pooling.
Mixing
For the preparation of mortar adhesive, pour into a
container 5 – 6.8 liters of water for each 20Kg bag of
Vetonit Ultra.
Add the powder to the water and mix for 3-4
minutes using a low- speed electric drill fitted with a
suitable paddle, until achieving a uniform, lump-free
consistency. Allow the mixed material to stand for
about 10 minutes and remix briefly without adding
further water.
Blend Vetonit Ultra manually for small quantities but
ensure to maintain the correct amount of powder to
water.
If required, add 0.5 Ltr of Saveto Bond 2 to the mixing
water, followed by powder’s addition. Use the mixed
material within 2 hours.
Do not add water to the mixture once the mortar
adhesive starts to harden.
Application
Spread the mixed mortar adhesive and firmly press it
onto the surface that will receive the tiles; work with a
notched trowel. Spread the mortar adhesive to an area
that can be tiled within 10-15 minutes. Press the tiles
firmly over the mortar adhesive and immediately knock
them into the desired position. Adjust the position of
the tiles, if required, within its adjustability time of 10-
15 minutes after installation.
Allow the installed tiles to remain undisturbed for at
least 48 hours. Mortar adhesive must not rise between
the tile joints higher than halfway the thickness of the
tiles. It is recommended to use Vetonit Tile Grout to fill
the joint gaps after 2 days of tile installation.
For further information regarding the suitable
substrates and tiles on which this product can be safely
applied, please contact Saveto technical department.
Cleaning
Clean tools and equipment with water immediately
after use. Remove the hardened material using
mechanical means.
Packaging & Coverage
Stated consumption data are for general guidance.
Actual consumption depends on the nature of the
substrate, method of application, and wastages.
Shelf Life & Storage
The original sealed bag of Vetonit Ultra has a shelf life
of 12 months, provided it is stored clear of ground in a
dry, shaded place below 35oC.
Health & Safety
Vetonit Ultra is highly alkaline; therefore, avoid direct
contact with eyes or skin. It is recommended to use
protective gloves and goggles during application. Any
skin contact should be washed with soap & water. In
case of eye irritation, immediately wash with a copious
amount of clean cold water. Seek medical advice.
Vetonit Ultra is non-flammable.
