Surface Preparation
The surface should be sound, clean, free from loose
material, grease, laitance, dirt, curing compound, etc.
Wet all surfaces with clean water before the application
of Pool Fix. The surface should appear damp with no
water pooling.
Mixing
To prepare mortar adhesive, pour into a container 7.5-
8 liters of water for a 25kg bag of Pool Fix. Add the
powder to the water and mix with a low-speed electric
drill fitted with a suitable paddle for 3-4 minutes until
achieving a uniform, lump-free consistency. Allow the
mixed material to stand for about 10 minutes and remix
briefly without adding further water.
Blend Pool Fix manually for small quantities but ensure
to maintain the correct amount of powder to water.
If required, add 0.5 Ltr of Saveto Bond 2 to the mixing
water, followed by powder’s addition. Use the mixed
material within 2 hours.
Do not add water to the mixture once the mortar
adhesive starts to harden.
Application
Spread the mixed mortar adhesive, and firmly press it
onto the surface that will be tiled; work with a notched
trowel. Spread the mortar adhesive to an area that can
be tiled within 10-15 minutes. Press the tiles firmly over
the mortar adhesive and immediately knock them into
the desired position. Adjust the position of the tiles, if
required, within its adjustability time of 10-15 minutes
after installation.
Allow the installed tiles to remain undisturbed for at
least 48 hours. Mortar adhesive must not rise between
the tile joints higher than halfway the thickness of the
tiles. It is recommended to use Vetonit Pool Grout to fill
the joint gaps after 2 days of tile installation.
For further information regarding the suitable
substrates and tiles on which this product can be safely
applied, please contact Saveto technical department.
Cleaning
Clean tools and equipment with water immediately
after use. Remove the hardened material using
mechanical means.
Packaging & Coverage
Stated consumption data are for general guidance.
Actual consumption depends on the nature of the
substrate, method of application, and wastages.
Shelf Life & Storage
The original sealed bag of Pool Fix has a shelf life of 12
months, provided it is stored clear of ground in a dry,
shaded place below 35oC.
Health & Safety
Pool Fix is highly alkaline; therefore, avoid direct
contact with eyes or skin. It is recommended to use
protective gloves and goggles during application. Any
skin contact should be washed with soap & water. In
case of eye irritation, immediately wash with a copious
amount of clean cold water. Seek medical advice.
Pool Fix is non-flammable.
